Enterasys Networks XSR CLI - page 519

Other ADSL Commands
XSR CLI Reference Guide 13-93
Syntax of the “no” Form
Thenoformofthiscommandremovesanyformofencapsulation,effectivelydisablingthesub‐
interface:
no encapsulation
Mode
ATMSub‐Interfaceconfiguration:XSR(config-if<ATMxx.x>)#
Default
Thedefaultencapsulationisnone.Anencapsulationmethodmustbespecifiedbeforethesub‐
interfacecanpassdata.Whenthesub‐interfaceisconfiguredforPPPoEencapsulation,thesource
EthernetMACaddresswillbesettotheMACaddressofFastEthernetinterface2.
Example
Thefollowingexampleconfiguresthesub‐interfaceforLLC/SNAPmultiplexingandPPPoA
encapsulatedtraffic:
XSR(config-if<ATM0/1/0.1>)#encapsulation snap pppoa
exit
ThiscommandquitstheATMSub‐InterfacemodeandreturnstoGlobalmode.
Syntax
exit
Mode
ATMSub‐Interfaceconfiguration:XSR(config-if<ATMxx.x>)#
Example
Thefollowingexampleexitsthesub‐interfaceATMcommandmodefromATMinterfaceslot0,
card1,port0,sub‐interface1:
XSR(config-if<ATM0/1/0.1>)#exit
XSR(config)#
ip address
ThiscommandspecifiestheIPaddressandsubnetmaskoftheATMsub‐interfaceorrequeststhe
IPaddressandsubnetmaskbenegotiated.Thiscommandrequiresaproperlyconfigured���ATM
sub‐interface.
service
-name
ThenameofthePPPoEservice.Ifnotspecified,PPPoEconnectstothefirst
advertisedservicename.Atthistime,theXSRwillconnectwiththefirst
advertisedservicenameonly.