Enterasys Networks XSR CLI Parameters in the Sub-Interface Response

ATM Clear and Show Commands
13-110 Configuring ADSL
Parameters in the Sub-Interface Response
ThelastsectioncontainstheMIB2interfacetableasdescribedinRFC‐1213.
General info:MIB2interfacetableentriesasdescribedinRFC‐1213including
AISF4,RDIF4,CCF4,LPBKF4.
ThelastfourfieldsintheGeneralinfosectioncountthenumber
OAMcells(bytype)receivedbytheinterfaceontheVirtualPath
(F4)flow.
Thecircuittableattheendofthedisplaylistsalltheconfigured
ATMsub‐interfacesrelatedtothisATMinterface.
•VPI/VCI‐PVCcircuitidentifier.
•AAL5‐SumofAAL5framesreceived.
•AIS‐SumofreceivedAlarmIndicationSignalcellsreceived.
•RDI‐SumofRemoteDefectIndicationcellsreceived.
•CC‐SumofContinuityCheckcellsreceived.
•LPBK‐SumofLoopbackcellsreceived.
•AIS/RDI
‐thecurrentalarmstateofthecircuit:AISorRDI
ATM 1/0.1 is Admin Up / Oper Up Administrativestate:AdminUporAdminDown;Operational
state:OperUporOperDown.
Internet address is 30.0.0.11,
subnet mask is 255.255.255.255
IPlayerinformation.
LCP State: OPENED/IPCP
State: OPENED
PPPlayerinformation.
PPP Layer Information
PPPoE is Oper Up
The logical link is currently Up
The Name of the Access Concentrator
is ENTERASY-CDDU1S
The Session Id is 0x000b
The MAC Address of the Access
Concentrator is
0x00:60:f9:11:01:08
The MTU is 1492
The name of this device is adsl-0 Hardwaredevicename.
Administrative state is ENABLED Driveradministrativestate:ENABLEDorDISABLED.
Operational State is UP Driveroperationalstate:UPorDOWN
Circuit monitoring enabled/Circuit
monitoring disabled
Circuitmonitoringoperationalstate.Thislinewillonlybe
displayedwhenOAMproceduresareenabledbytheOAM-PVC
commandandtheADSLlineisUP.
VPI is 1/VCI is 32 VirtualPathIndexandVirtualCircuitIndexfortheATMPVC.