Enterasys Networks XSR CLI manual speed

Hardware Controller Commands
XSR CLI Reference Guide 4-89
Mode
Interfaceconfiguration:XSR(config-if<Sx>)#
Default
Sync
Example
XSR(config-if<S1/0>)#physical-layer async
shutdown
Thiscommanddisablesaninterface.Whentheinterfaceiscreated,itisdisabledbydefault.
Syntax
shutdown
Syntax of the “no” Form
no shutdown
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Default
Whentheinterfaceiscreated,itisdisabledbydefault.
Example
XSR(config-if<S1/0>)#no shutdown
speed
Thiscommand,usedinconjunctionwiththeduplexcommand,forcestheFastEthernetinterface
tooperateataspecificspeedand/orduplexmode.Settingthespeedorduplextoauto‐negotiate
impliesthatboththespeedandtheduplexmodewillbenegotiated.Itisnotpossibletomanually
setoneandauto‐negotiatetheother.Forexample,youcannotsetthespeedto10Mb/sandsetthe
duplextoauto‐negotiate.
ForGigabitEthernetonly,toset1000Mbitsspeedforcopperorfiber,selectautowhichwill
autosensethecorrectlineandduplexspeeds.
Keepinmindthefollowingcaveats:
• Changingthespeedpreservesthecurrentduplexmode.
Note: Issuing this command causes the interface to drop its link while disabled.