Enterasys Networks XSR CLI frame-relay lmi-n391dte, frame-relay lmi-n392dce

Frame Relay Commands
XSR CLI Reference Guide 9-89
frame-relay lmi-n391dte
Thiscommandsetsthefullstatus‐pollingintervalwhentheDigitalTerminalEquipment(DTE)
interfaceisconfiguredtosetthefullstatusmessage‐pollinginterval.
Syntax
frame-relay lmi-n391dte num_ka-exchanges
Syntax of the “no” Form
Thenoformofthiscommandrestoresthedefaultintervalvalue:
no frame-relay lmi-n391dte
Default
6
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Example
Thisexampleestablishesthatastatusinquirywillbesenteveryfivesecondsandthatoneofevery
tenstatusinquiriesgeneratedwillrequestafullstatusresponsefromtheFrameRelayswitch.The
otherninestatusinquirieswillrequestkeep‐aliveexchangesonly:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#frame-relay intf-type dte
XSR(config-if<S1/0>)#frame-relay lmi-n391dte 10
XSR(config-if<S1/0>)#frame-relay lmi-t391dte 5
XSR(config-if<S1/0>)#no shutdown
frame-relay lmi-n392dce
ThiscommandsetstheerrorthresholdonaDataCommunicationsEquipment(DCE)interface.
Syntax
frame-relay lmi-n392dce threshold
Syntax of the “no” Form
Thenoformofthiscommandremovesthecurrentsetting:
no frame-relay lmi-n392dce
num_ka-exchanges Numberofkeep‐aliveexchangestooccurbeforerequestingafull
statusmessage,rangingfrom1to255.
threshold Errorthreshold,rangingfrom1to10.