Enterasys Networks XSR CLI BRI Switch Types:, PRI Switch Types:

ISDN Commands
Book Title goes here 11-89
Syntax
isdn switch-type switch-type {basic-dms100 | basic-ni1 | basic-ntt | basic-net3 |
primary-net5 | primary-ni2 | primary-5ess | primary-dms100 | primary-ntt}
BRI Switch Types:
PRI Switch Types:
Syntax of the “no” Form
Thenoformofthiscommanddeletesthethreeserialinterfaces:
no isdn switch-type
Defaults
•BRI:basic‐net3
•PRI:primary‐net5
•E1:primary‐net5
•T1:primary‐ni2
•J1:primary‐ntt
Mode
BRI/PRIInterfaceconfiguration:XSR(config-if<BRI/PRI-xx>)#
Note: This command is valid only after the pri-group command was issued.
basic-dms100 NorthAmericalegacyISDNswitch.
basic-ni1 NationalISDN1switchforNorthAmerica.
basic-5ess NorthAmericalegacyISDNswitch:notsupported.
basic-ntt SwitchforISDNinJapan.
basic-net3 ETSI‐compliantswitchforEuro‐ISDN.
primary-net5 ETSI‐compliantswitchforEuro‐ISDN.
primary-ni2 T1NationalISDNswitchtype(T1default).
primary-5ess T1NOAMlegacyswitch.
primary-dms100 T1NOAMlegacyswitch.
primary-ntt T1/J1ISDNswitchforJapan.