Enterasys Networks XSR CLI ip pim dr-priority, ip pim message-interval

PIM Commands
XSR CLI Reference Guide 7-91
ip pim dr-priority
ThiscommandsetsthepriorityforwhicharouteriselectedastheDesignatedRouter(DR).
Syntax
ip pim dr-priority priority-value
Syntax of the “no” Form
ThenoformofthiscommanddisablestheDRfunctionality:
no ip pim dr-priority
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Defaults
•DRfunctionalityisdisabledontheinterface
•DR‐priority:1
Example
ThefollowingexamplesetstheDRpriorityvalueofF1to20:
XSR(config-if<F1>)#ip pim dr-priority 20
ip pim message-interval
ThiscommandconfiguresthefrequencyatwhichaProtocolIndependentMulticastSparseMode
(PIM‐SM)routersendsperiodicjoinandprunemessages.
Syntax
ip pim message-interval seconds
Syntax of the “no” Form
Thenoformofthiscommandsetstheintervaltothedefaultvalue:
no ip pim message-interval
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
priority-value Preferencevalue,rangingfrom0to4294967294,tosetthepriorityofthe
routerforselectionastheDR.
seconds IntervaltosendperiodicPIM‐SMjoinandprunemessages.Range:1to65535.