Enterasys Networks XSR CLI Configuring the Dialer Interface

XSR CLI Reference Guide 10-83
10
Configuring the Dialer Interface
Thischapterdescribescommandsforthedialer,dialerbackup,andDial‐on‐Demand/Bandwidth‐
on‐Demandservices.
Observing Syntax and Conventions
TheCLIcommandsyntaxandconventionsusethenotationdescribedinthefollowingtable.
Dialer Interface Commands
ThefollowingsetofcommandsdefinesdialservicesontheXSR:
• DialerInterfaceClearandShowcommandsonpage10‐90.
• DialerBackupcommandsonpage10‐93.
• DOD/BODcommandsonpage10‐96.
• DialerWatchcommandsonpage10‐103.
dialer dtr
Thiscommandspecifiesthatanon‐V.25bismodemusingElectronicIndustriesAssociation(EIA)
signalingwillbeusedontheseriallineinterface.ThissignalisknownastheDTRsignal.The
dialer stringcommandhasnoeffectonDTRdialers.Beawareofthefollowingmandatory
conditions:
Convention Description
xyz Key word or mandatory parameters (bold)
[x][ ] Square brackets indicate an optional parameter (italic)
[x | y | z][ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z}{ | } Braces with vertical bar indicate a choice of a required value
[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars indicates a
required choice of an optional parameter
(config-if<xx>)xx signifies interface type and number, e.g.: F1, S2/1.0, D1, M57, L1,
ATM0/1/1
Next Mode entries display the CLI prompt after a command is entered
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis