Enterasys Networks XSR CLI show interface dialer, DOD/BOD Commands, dialer-group

DOD/BOD Commands
10-96 Configuring the Dialer Interface
show interface dialer
Thiscommanddisplaysgeneralinformationforadialerinterface.
Syntax
show interface dialer number
Mode
PrivilegedEXEC:XSR#
Sample Output
Theexamplebelowdisplaysoutputfromtheshow interface dialer command:
XSR#show interface dialer
********** Dialer Interface Stats **********
Dialer1 is Admin Up
Internet address is 10.10.10.1, subnet mask is 255.255.255.0
Dialer1
Dialer state is: UP
Wait for carrier default: 60, default retry: 3
Dial String Success Failures Map Class
Dialer pool 3
(Serial 2/0:0, )
Free pool ISDN channels: <25>
Free pool serial ports: <0>
Neighbor Dial String Success Failures Map Class
3100 1 0
Active links MLPPP group <1> to <10.10.10.2>: <5>
DOD/BOD Commands
TheXSRsupportsthefollowingDialonDemand(DoD)/BandwidthonDemand(BoD)
commands.
dialer-group
Thiscommandcontrolsdialeraccessbyconfiguringaninterfacetobelongtoaspecificdialing
group.Thisaccessgroupisassociatedwithanaccesslistbythedialer-list command.
Packetswhichmatchthedialergrouptriggeraconnectionrequest.Thatis,thedestinationaddress
ofpacketsisevaluatedagainstoneormoreACLs;ifthepacketspass,eitheracallisinitiated(ifno
connectionwerealreadyestablished)ortheidletimerisreset(ifacallisactive).
number Dialer interface number ranging from 0 to 255