Enterasys Networks XSR CLI - page 355

PPP Commands
XSR CLI Reference Guide 8-85
Syntax
interface type slot_num card_num port_num sub-interface_num
Slots,cards,ports,andsub‐interfacesareexpressedasfollowsontheCLI:
Syntax of the “no” Form
Thenocommanddeletestheinterface:
no interface serial port_num interface_num
Mode
Globalconfiguration:XSR(config)#
Examples
Thisexampleselectsinterfaceserial1/0andsetsPPPencapsulation:
type ATM,BRI,Dialer,Fast/GigabitEthernet,Loopback,Multilink,SerialorVPN
port.
slot_num TheNIMnumberrangingfrom0to6dependingontheXSRmodel.
card_num TheNIMcardnumberrangingfrom1to2dependingontheNIMinstalledin
theslot.
port_num Thephysicalportnumberrangingfrom:0(ATM),0to1(BRI),0to255(Dialer
&VPN),0to15(Loopback),1to32767(Multilink),0to3(Serial),1to2
(FastEthernet),1to3(GigabitEthernet),and0(Console).
IfaSerialportresidesonaT1/E1port,thenchannelgroupdatamustbe
addedattheendofthestringtomarkwhichchannelgroupoftheT1/E1port
willbeset:
card_num/NIM_num/port_within_NIM:[channel‐group_num].
Forexample,0/2/1:15setschannel‐group15oftheT1orE1port1inNIMslot
2onthemotherboard.
sub-
interface_num
Numberrangingfrom1to30(ATM,BRI&Serial),and1to64(Fast/
GigabitEthernet).
0Theconsoleport.(OnlyontheXSR1800series)
<0-0>/<1-2>/<0-3> Slot,card,andportnumber.
<1-2>/<0-3> Cardandportnumber.
<1-2>/<0-3>.<1-30> Card,portandsub‐interfacenumber.
<1-2>/<0-3>:<0-31> Card,portandchannelnumber.
<1-2>/<0-3>:<0-31> .<1-30> Card,port,channelandsub‐interfacenumber.
Note: Leading zeros defined in interface_num can be omitted. For example, 0/1/2 is equivalent to 1/2.
Note: You cannot directly delete a Serial interface assigned to a T1/E1 channel group. You must
instead delete a channel group to delete the Serial port.