Enterasys Networks XSR CLI dialer wait-for-carrier-time (map-class dialer configuration), interface dialer

Dialer Interface Commands
XSR CLI Reference Guide 10-87
Example
Thefollowingexamplespecifiesawaittimeof90secondsforthecarriersignalonserialport1/0:
XSR(config-if<S1/0>)#dialer wait-for-carrier-time 90
dialer wait-for-carrier-time (map-class dialer configuration)
Thiscommandconfiguresthetimetowaitforacarriersignalassociatedwithaspecificdialermap
class.Dialermapclassesareusedtoconfigurecertaincharacteristicswithdialerstringswhen
configuringdialerports.
Syntax
dialer wait-for-carrier-time seconds
Syntax of the “no” Form
Thenoformofthiscommandresetstothedefaultvalue:
no dialer wait-for-carrier-time
Default
60seconds
Mode
Map‐classdialerconfiguration:XSR(config-map-class)#
Example
Theexamplebelowspecifiesa120‐secondwaittimeforthecarriersignalofthedialermapclass
TESTonDialerport57:
XSR(config-if<D57>)#interface dialer 57
XSR(config-if<D57>)#ip address 196.16.25.1 255.255.255.0
XSR(config-if<D57>)#encapsulation ppp
XSR(config-if<D57>)#dialer remote-name SiteA
XSR(config-if<D57>)#dialer string 4165555584 class TEST
XSR(config-if<D57>)#dialer pool 1
XSR(config)#map-class dialer TEST
XSR(config-map-class)#dialer wait-for-carrier-time 120
interface dialer
Thiscommandaddsadialerinterfacetoconnectwithoneormorespecifiedsub‐networks.A
dialerinterfaceconnectstoadialdeviceviaapoolofphysicalports.
Thedialerinterfaceiscreatedintwoways:point‐to‐pointorpoint‐to‐multipointbyusingthe
multipointparameter.Whenconfigured,thedialerlineisnotphysicallyconnectedbuttheentryis
maintainedintheroutingtablethuspreservingon‐demandaccesswheninterestingpacketsare
receivedandacceptedbyanAccessControlList(ACL).
seconds Interval the port waits for a carrier signal when a call is placed through the dial device.