Enterasys Networks XSR CLI ppp bap timeout

Multilink PPP Commands
8-112 Configuring the Point-to-Point Protocol
Syntax
ppp bap number {default phone-number}
Syntax of the “no” Form
ThenocommandremovesaBAPphonenumber:
no ppp bap number {default phone-number}
Mode
DialerInterfaceconfiguration:XSR(config-if<Dx>)#
Example
ThefollowingexamplespecifiestheBAPdefaultphonenumber:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#ppp bap number
ppp bap timeout
ThiscommandconfiguresBandwidthAllocationProtocol(BAP)actiontimeoutstosetup
Bandwidth‐on‐Demand(BoD).
Themultilink load-thresholdcommandisasecondmeansbywhichtheXSRcontrolstraffic
viaBoD.Itisalsoprovidedbysettingthemultilink min-links command.
Syntax
ppp bap timeout {pending seconds | response seconds}
Syntax of the “no” Form
ThenocommanddeletesBAPactiontimeouts:
no ppp bap timeout {pending | response}
Defaults
•Pendingseconds:20
• Responseseconds:20
Mode
DialerInterfaceconfiguration:XSR(config-if<Dx>)#
default phone-number Primarynumberforincomingcalls.Upto5numberscanbeentered.
pending seconds Waitintervalforpendingactions.Range:2to180seconds.
response seconds Waitintervalforresponsepackets.Range:2to180seconds.