Enterasys Networks XSR CLI Dialer Watch Commands dialer watch-group, dialer watch-list

Dialer Watch Commands
XSR CLI Reference Guide 10-103
Dialer Watch Commands
dialer watch-group
ThiscommandenablesDialerWatchbackuponadialerinterfacewithupto16watch‐groups.
Syntax
dialer watch-group group-number
Syntax of the “no” Form
Usethenoformofthiscommandtodisablethisfeature:
no dialer watch-group group-number
Mode
DialerInterfaceconfiguration:XSR(config-if<Dx>)#
Example
Thefollowingexampleconfiguresadialerwatchgroup:
XSR(config-if<D3>)#dialer watch-group 57
dialer watch-list
ThiscommandaddsalistofIPaddressesyouwantmonitored.Usethiscommandwiththedialer
watch‐groupinterfaceconfigurationcommand.Thenumberofthegrouplistmustmatchthe
groupnumber.
Syntax
dialer watch-list group-number [delay route-check initial initial-delay][delay
connect connect-delay][delay disconnect disconnect-delay][ip ip-address address-
mask]][time-range start-time end-time]
Note: The XSR sets UTC for time-range calculation.
group-number Assigned number that will point to a globally defined list of IP addresses to
watch, ranging from 1 to 255.f
Note: The XSR sets UTC for time-range calculation.
group-number Number assigned to the list, ranging from 1 to 255.
ip IP is the only routed protocol supported for Dialer Watch at this time.
ip-address IP address or address range to be applied to the list.