5 POWER-DOWN CONTROL

5 Power-Down Control

This chapter describes the controls used to reduce power consumption of the device.

Points on power saving

The current consumption of the device varies greatly with the CPU's operation mode, the system clocks used, and the peripheral circuits operated.

Current consumption

low←

 

 

 

 

→ high

CPU/BCU

SLEEP

HALT2

Operating

HALT2

HALT(basic)

Operating

System clock

–

OSC1

OSC1

OSC3

OSC3

OSC3

OSC3 oscillation circuit

OFF

OFF

OFF

ON

ON

ON

Prescaler/peripheral circuit

STOP

 

 

 

 

RUN

To reduce power consumption of the device, it is important that as many unnecessary circuits as possible be turned off. In particular, peripheral circuits operating at a fast-clock rate consume a large amount of current, so design the program so that these circuits are turned off whenever unnecessary.

Power-saving in standby modes

When CPU processing is unnecessary, such as when waiting for an interrupt from key entries or peripheral circuits, place the device in standby mode to reduce current consumption.

Standby mode

Method to enter the mode

Circuits/functions stopped

Basic HALT mode

Execute the halt instruction after setting

CPU and DMA

 

HLT2OP (D3)/Clock option register

 

 

(0x40190) to "0".

 

 

When the #BUSREQ signal is asserted from

 

 

an external bus master while SEPD (D1)/Bus

 

 

control register (0x4812E) = "1".

 

HALT2 mode

Execute the halt instruction after setting

CPU, BCU, bus clock, and DMA

 

HLT2OP to "1".

 

SLEEP mode

Execute the slp instruction.

CPU, BCU, bus clock, DMA, high-speed

 

 

(OSC3) oscillation circuit, prescaler, and

 

 

peripheral circuits that use the prescaler

 

 

output clocks

HLT2OP (D3)/Clock option register (0x40190) that is used to select a HALT mode is set to "0" (basic HALT mode) at initial reset.

Notes: • In systems in which DRAM is connected directly to the device, the refresh function is turned off during HALT2 and SLEEP modes.

•The standby mode is cleared by interrupt generation (except for the basic HALT mode, which is set using an external bus master). Therefore, before entering standby mode, set the related registers to allow an interrupt to be used to clear the standby mode to be generated.

•When clearing the standby mode with an interrupt from port input, the interrupt operates as a level interrupt regardless of the interrupt trigger setting. When edge trigger is set for the interrupt trigger, attention must be paid to the port level during standby mode.

The low-speed (OSC1) oscillation circuit and clock timer continue operating even during SLEEP mode.If they are unnecessary, these circuits can also be turned off.

Function

Control bit

"1"

"0"

Default

Low-speed (OSC1) oscillation ON/OFF control

SOSC1(D0)/

ON

OFF

ON

 

Power control register(0x40180)

 

 

 

A-62

EPSON

S1C33210 PRODUCT PART