HP 3200 manual Problem, Cause, Solution, against the sides of the stack in the paper

Problem	Cause	Solution
The product is	Guides are not adjusted properly.	Remove the media from the paper input
feeding		tray or the single-sheet input slot. Tap the
multiple sheets		sides of the media stack together, then
or jams		reinsert the stack. Or, reinsert the single
		sheet into the slot. Slide the guides
frequently from
		against the sides of the stack in the paper
the paper input
		input tray or against the single sheet in the
tray or single-
		single-sheet input slot to center the paper.
sheet input
		Make sure the guides are not adjusted too
slot.		tightly.
	Additional media was added to the paper	Remove all of the media from the paper
	input tray without unloading and	input tray. Tap the sides of the media
	straightening all of the media first.	stack together, and then reinsert the
		paper.
	The paper input tray is too full.	Remove some of the sheets. The paper
		input tray can hold up to 125 sheets of 20-
		lb (75g/m2) bond weight paper (less for
		heavier paper) or up to 7 to 10 envelopes,
		depending on envelope construction and
		operating environment
	More than one sheet was placed in the	Place only one sheet at a time in the
	single-sheet input slot.	single-sheet input slot. If printing more
		than one sheet of the same type of media,
		use the paper input tray.
	The paper was poorly cut by the	“Break” the ream of paper by curving it
	manufacturer and is sticking together.	into an upside-down u-shape; this may
		effectively decrease multifeeds. You may
		also try turning the paper around to feed
		the opposite end first, or use a different
		type of paper.
	The paper does not meet HP’s	Order HP’s paper specification guide. To
	specifications for print media.	order, see Ordering parts (page 257).
	The output capacity was exceeded in the	Do not allow more than 125 sheets of 20-
	paper output bin or front paper output slot.	lb (75 g/m2) bond weight paper (less for
		heavier paper) to fill the paper output bin.
		Do not allow media to stack up in front of
		the front paper output slot.
	The pick rollers are dirty and are not	See “Cleaning the print paper path” on
	grabbing the paper.	page 211.

EN Resolving paper feed problems 173