HP 3200 manual JOB Settings

Message	Cause	Solution
INVALID DATE	An invalid date was entered, such as June	Reenter the date.
	35.
INVALID TIME	An invalid time was entered, such as	Reenter the time.
	25:99 PM.
JOB SETTINGS	The product has cleared job settings.	Reenter any desired job settings.
CLEARED
MEMORY LOW.	The product completed making one copy.	Press ENTER/MENU to clear the error.
ONLY 1	The remaining copies have been	Use the HP LaserJet Director to make
	canceled due to low product memory.	multiple copies of large documents, or
COPY. PRESS
		break the job into smaller jobs
[STOP]		containing fewer pages.
MEMORY LOW.	The product memory has been almost	Allow the product to finish the job or
[STOP] TO	completely filled.	press STOP/CLEAR to cancel the job.
CANCEL.
NO DIAL TONE.	The product could not detect a dial tone.	Unplug the telephone cord from both the
		product and the wall, and replug the
		cord.
		Unplug the product telephone cord from
		the wall, plug in a telephone, and try
		making a call.
		Plug the product phone cord into a jack
		for another phone line.
		See “Changing the detect dial tone
		setting”.
		See “Resolving fax problems” on
		page 149.
NO DOCUMENT	The fax forwarding setting is on, and the	Print the faxes in memory and have the
SENT	product was unsuccessful in receiving a	sender resend the missing page(s) of
	fax because of low memory or some other	the document.
	reason. The product deleted the
	incomplete received data before
	attempting to forward the deleted data.
NO FAX	The product answered the incoming call	Ask the sender to try resending the fax.
DETECTED	but could not determine that the caller was	Unplug the product telephone cord from
	a fax machine.	the wall, plug in a telephone, and try
		making a call.
		Plug the product phone cord into a jack
		for another phone line.
		See “Resolving fax problems”.
NO FAX PAGES	The product attempted to execute	Receive a fax before attempting to use
IN	“Reprint Last Fax” when nothing was in	this option.
	memory.
MEMORY TO
REPRINT
NOT ENOUGH	There is not enough memory to start a	Wait until the current job is finished
MEMORY.	new job.	before starting a new job.
TRY AGAIN
LATER

EN Resolving control panel error messages 199