Problem | Cause | Solution | |
|
|
| |
The product is | The special media lever might be in the | The special media lever should be to the | |
feeding | incorrect position. | left if you are sending | |
multiple sheets |
| media. The lever should be to the right if | |
or jams |
| you are sending thick media, which can | |
| only be loaded one page at a time. | ||
frequently from |
| ||
|
| ||
the document | Guides are not adjusted properly. | Remove the document from the document | |
feeder tray. | |||
| feeder tray. Straighten the item, then | ||
|
| ||
|
| reinsert it. Slide the guides against the | |
|
| sides of the items to center it. Make sure | |
|
| the guides are not adjusted too loosely. | |
| The document feeder tray is too full. | Remove some of the sheets. The | |
|
| document feeder tray can hold up to 30 | |
|
| pages, depending on the thickness of the | |
|
| pages. | |
| The item was too thick, too slick, or | See “Selecting print media” on page 23. | |
| otherwise did not meet the recommended |
| |
| specifications. |
| |
|
|
| |
Items loaded in | The items are on very lightweight media. | Do not try to pull the page out, because | |
the document |
| you can damage the scanner. To remove | |
feeder tray fall |
| the page, see “Clearing jams from the | |
forward out of |
| scanner path areas” on page 177. Then, | |
the tray. |
| curl or roll the item in the direction of the | |
| printed side, unroll it, and reload the item. | ||
|
| ||
|
|
|
178 Chapter 8 - Problem Solving and Product Maintenance | EN |