HP 3200 manual Power Fail

Message	Cause	Solution
POWER FAIL	The product has detected a power failure	The product should go back to the ready
RECOVERY.	and is performing a self-test.	state on its own. If this message does
		not go away in a couple of minutes,
CHECKING
		disconnect the power cable from the
SYSTEM		product, wait at least 30 seconds, then
		reconnect the power cable, and wait for
		the product to initialize.
POWER FAIL	The product has detected a power failure	Press ENTER/MENU to clear the error.
RECOVERY.	and the last update to the fax settings was	The product should go back to the ready
	corrupted. The product is resetting all fax	state.
FAX SETTING
	settings back to the factory default
RESET	settings.
POWER FAIL	The product has detected a power failure	The product prints all of the received
RECOVERY.	and is printing all of the faxes that it did	faxes that it did not previously print.
	not previously print.	Once the faxes are printed, the product
PRINTING
		will go back to the ready state.
FAXES
POWER FAIL	The product has detected a power failure	The product resends the unsent faxes.
RECOVERY.	and has also detected unsent faxes and	Once the faxes are sent, the product will
	will try to resend them.	go back to the ready state.
SEND:[FAX
NUMBER]
POWER OFF.	The DIMM in the indicated slot has failed.	Turn off the product and check the
CHECK DIMM		indicated DIMM.
#[1-3]
PRINTER PAPER	The product has detected that a jam has	Clear the jam. (See “Clearing jams from
JAM	occurred.	the printer path areas” on page 170.)
		The job should continue to print. If it
CLEAR PAPER
		does not, try reprinting the job.
PATH
PRINTER DOOR	The printer door is open, or the toner	Make sure the printer door is closed.
OPEN OR	cartridge is not installed properly.	Check the toner cartridge for proper
		installation. See “To install the toner
NO TONER
		cartridge” in the Getting Started Guide
CARTRIDGE		for instructions.
PRINTER PAPER	The paper input tray is empty.	Load media. If media is already loaded,
TRAY		remove it. Check for and remove any
		jam, and then reload the paper stack in
IS EMPTY. ADD
		the paper input tray.
PAPER
PRINTER TRAY	The print engine has failed to pick up a	Reload the paper in the paper input tray,
MISPICK.	piece of media.	and press ENTER/MENU to continue the
		job.
[ENTER] TO
RESUME

200 Chapter 8 - Problem Solving and Product Maintenance EN