Intel mcs-48 manual 8755A, Comment, Symbol Parameter MIN MAX VIL, Ready Hold Time

8755A

ABSOLUTE MAXIMUM RATINGS·

TemperatureUnderBias	-10oe to +70o e
Storage Temperature	-65°eto +150 o e
Voltage on Any Pin
With Respect to Ground	-0.5 to +7V·
Power Dissipation	1.5W
·Except for programming voltage.

'COMMENT

Stresses above those listed under "Absolute Maximum Ratings" maycause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those

Indicated in the operational sections of this specification is not implied.

Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

D.C. CHARACTERISTICS (TA = o°c to 70°C; VCC = 5V ± 5%)

SYMBOL	PARAMETER	MIN.	MAX.
VIL	Input Low Voltage	-0.5	0.8
VIH	Input High Voltage	2.0	Veet<l·5
VOL	Output Low Voltage		0.45
VOH	Output High Voltage	2.4
IlL	Input Lea kage		10
ILO	Output Leakage Current		tl0
Ice	Vec Supply Current		180

A.C. CHARACTERISTICS (TA = o°c to 70°C; Vee = 5V ± 5%)

UNITS	TEST CONDITIONS
V
V
V	IoL=2mA
V	IoH = -400JjA
JjA	VIN = Vcc to OV
JjA	0.45V ';;VOUT';;Vee
mA

SYMBOL	PARAMETER	MIN.	MAX.	UNITS	TEST CONDITIONS
teye	Clock Cycle Time	320		ns
T,	ClK Pulse Width	80		ns	CLOAO = 150 pF
T2	ClK Pulse Width	120		ns	(See Figure 3)
tf ,t,	ClK Rise and Fall Time		30	ns
tAL	Address to Latch Set Up Time	50		ns
tLA	Address Hold Time after latch	80		ns
tLe	latch to READ/WRITE Control	100		ns
tAD	Valid Data Out Delay from READ Control		170	ns
tAO	Address Stable to Data Out Valid		450	ns	150 pF load
tLL	Latch Enable Width	100		ns
tAOF	Data Bus Float after READ	0	100	ns
teL	READIWRITE Control to latch Enable	20		ns
tee	R EADIWR ITE Control Width	250		ns
tow	Data In to WRITE Set Up Time	150		ns
two	Data In Hold Time After WR ITE	30		ns
twp	WR ITE to Port Output		400	ns
tpA	Port Input Set Up Time	50		ns
tAP	Port Input Hold Time	50		ns
tAYH	READY HOLD TIME	0	160	ns
tAAY	ADDRESS (CE) to READY		160	ns
tAv	Recovery Time between Controls	300		ns
tADE	Data Out Delay from READ Control	10		ns
tLO	ALE to Data Out Valid		350	ns	Preliminary

6-77