Motorola 3342, 7000, 3352N, 2200 manual Introduction, What’s New

CHAPTER 1 Introduction

What’s New in 7.7.4

New in Motorola Netopia® Embedded Software Version 7.7.4 are the following features:

•Internet Group Management Protocol (IGMP) Version 3 support. See “IGMP (Internet Group Management Protocol)” on page 100.

•TR-101 Support:

•Concurrent support for PPPoE and IPoE connections on the WAN. See “WAN” on page 67.

•Multiple LAN IP Subnet support. See “LAN” on page 49.

•Additional DHCP range support. These ranges are associated with the additional LAN subnets on a 1-to-1 basis.

•DHCP option filtering support. Allows DHCP option data to be used to determine the desired DHCP address range. See “DHCP Option Filtering” on page 252.

•Support for additional WAN settings to control multicast forwarding as well as if 0.0.0.0 is used as the source address for IGMP packets.

See “Advanced:” on page 69.

•Support for “unnumbered” interfaces. For IP interfaces, this allows the address to be set to 0 and the DHCP client also to be disabled. See page 71.

•PPPoE/DHCP Autosensing. See “WAN” on page 67.

•Wireless Multimedia Mode (WMM) support. See “WiFi Multimedia” on page 62.

•Firewall: ClearSailing is automatically enabled on all 2200-Series ADSL2+ platforms. (Explicit excep-

tions: bonded and VDSL2, 3341, and 3387WG.) See “Firewall” on page 142.

•TR-069 Remote device management is automatically enabled by default for 2200-Series Gateways. (Explicit exceptions: bonded and VDSL2, 3341, 3387WG). See “TR-069” on page 322.

•Voice-over-IP (VoIP) Support using Session Initiation Protocol (SIP) for supported models. See “VoIP” on page 120 and VoIP CLI “VoIP settings” on page 316.

•Support of VLAN ID 0 on the Ethernet WAN and support for setting p-bits on a segment/port basis; inter- VLAN groups. See “VLAN” on page 107 and CLI “VLAN Settings” on page 311.

•Backup IP Gateway Support. See “Backup” on page 133 and CLI “Backup IP Gateway Settings” on page 323.

Corresponding commands have been added to the Command Line Interface (CLI). See “Command Line Interface” on page 223.

•Reset WAN port and wireless counter and CLI command to display individual Ethernet port statistics. See “reset enet [ all ]” on page 231 and “show enet [ all ]” on page 233.

•CLI for Motorola Netopia® ATA Remote Management.

See “Remote ATA Configuration Commands” on page 243.

13