![](/images/new-backgrounds/1179718/179718659x1.webp)
Administrator’s Handbook
VDSL Parameters Accepted Values
Parameter | Accepted Values |
Bit 0, 1: Tx Cfg band | |
| 1- All tones on |
| 2- All tones below 640 Khz are turned off |
| 3- All tones below 1.1 Mhz are turned off |
| Bit 2,3: Not used |
| Bit 4,5: Rx Cfg band |
| 1- All tones on |
| 2- All tones below 640 Khz are turned off |
| 3- All tones below 1.1 Mhz are turned off |
| Bit 6, 7:Optional band |
| 0- No Optional band |
| 1- ANNEX_A_6_32 ( ie. 25KHz to 138 KHz) |
| 2- ANNEX_B_32_64 (ie. 138 KHz to 276 KHz) |
| 3- ANNEX_B_6_64 (ie. 25KHz to 276 KHz) |
Bit [0]: I 43 G.hs carrier set. | |
| Bit [1]: V 43 G.hs carrier set. |
| Bit [2]. A 43 G.hs carrier set. |
| Bit [3]: B 43 G.hs carrier set. |
| Bit[4:7]: shall be set to 0. |
0: 8.5dBm power output | |
| 1: 11.5 dBm power output |
0: using internal filter in Tx path | |
| 1: using K1 external filter in Tx path |
| (for Korea VLR Application) |
| 2: using U1 external filter in Tx path |
| (for US / Korea VLR Application) |
| 3: using H1 external filter in Tx path |
| (for 100/100 Application) |
0: using internal filter in Rx path | |
| 1: using K1 external filter in Rx path |
| (for Korea VLR Application) |
| 2: using U1 external filter in Rx path |
| (for US / Korea VLR Application) |
| 3: using H1 external filter in Rx path |
| (for 100/100 Application) |
Dying Gasp is a message sent from CPE to CO using the indica- | |
| tor bit. It indicates that the CPE is experiencing an impending |
| loss of power. |
| Off: Dying Gasp off (don't send a message to CO). |
| On: Dying Gasp on. |