Motorola 3342 Set igmp snooping off on, Set igmp robustness value, Set igmp query-intvl value

Administrator’s Handbook

determines that only a single wireless client is interested in the stream, it will once again unicast the stream.

set igmp snooping [ off on ]

Enables IGMP Snooping.

set igmp robustness value

Sets IGMP robustness range: from 2 – 255. The default is 2.

set igmp query-intvl value

Sets the query-interval range: from 10 seconds – 600 seconds, The default is 125 seconds.

set igmp query-response-intvl value

Sets the query-response interval range: from 5 deci-seconds (tenths of a second) – 255 deci-seconds. The default is 100 deci-seconds.

set igmp unsol-report-intvl value

Sets the unsolicited report interval: the amount of time in seconds between repetitions of a particular com- puter’s initial report of membership in a group. The default is 10 seconds.

set igmp version [ 1 2 3 ]

Sets the IGMP querier version: version 1, version 2, or version 3. If you know you will be communicating with other hosts that are limited to v1, for backward compatibility, select 1; otherwise, allow the default 3.

set igmp last-member-query-intvl value

Sets the last member query interval: the amount of time in tenths of a second that the IGMP gateway waits to receive a response to a Group-Specific Query message. The last member query interval is also the amount of time in seconds between successive Group-Specific Query messages. The default is 1 second (10 deci-seconds).

set igmp last-member-query-count value

Sets the last member query count: the number of Group-Specific Query messages sent before the gateway assumes that there are no members of the host group being queried on this interface. The default is 2.

set igmp fast-leave [ off on ]

Sets fast leave on or off. Set to off by default, fast leave enables a non-standard expedited leave mecha- nism. The querier keeps track of which client is requesting which channel by IP address. When a leave mes- sage is received, the querier can check its internal table to see if there are any more clients on this group. If there are none, it immediately sends an IGMP leave message to the upstream querier.

258