
•DoS Detect: If you check this checkbox, the Gateway will monitor packets for Denial of Service attacks.
•Exposed Addresses: The hosts specified in Exposed Addresses will be allowed to receive inbound traf- fic even if there is no corresponding outbound traffic. This is active only if NAT is disabled on a WAN interface.
•Stateful Inspection Options: Enable and configure stateful inspection on a WAN interface.
Exposed Addresses
You can specify the IP addresses you want to expose by clicking the Exposed addresses link.
Add, Edit, or delete exposed addresses options are active only if NAT is disabled on a WAN interface. The hosts specified in exposed addresses will be allowed to receive inbound traffic even if there is no corre- sponding outbound traffic.
•Start Address: Start IP Address of the exposed host range.
•End Address: End IP Address of the exposed host range
•Protocol: Select the Protocol of the traffic to be allowed to the host range from the
•Start Port: Start port of the range to be allowed to the host range. The acceptable range is from 1 - 65535
•End Port: Protocol of the traffic to be allowed to the host range. The acceptable range is from 1 - 65535