Administrator’s Handbook
reset security-log
Clears the security monitoring log to make room to capture new entries.
reset wan-users [all ip-address]
This function disconnects the specified WAN User to allow for other users to access the WAN. This function is only available if the number of WAN Users is restricted and NAT is on. Use the all parameter to discon- nect all users. If you logon as Admin you can disconnect any or all users. If you logon as User, you can only disconnect yourself.
reset wan
This function resets WAN interface statistics.
reset wepkeys
This function allows you to force your wireless WEP key settings back to the default values, if there are default values. For example, on some models, the WEP keys are based on the serial number. This allows you to get back those default settings if you have changed them without the need to reset the entire config- uration of the unit.
restart [seconds]
Restarts your Motorola Netopia® Gateway. If you include the optional seconds argument, your Motorola Netopia® Gateway will restart when the specified number of seconds have elapsed. You must enter the complete restart command to initiate a restart.
show all-info
Displays all settings currently configured in the Motorola Netopia® Gateway.
show backup
Displays the status of the Backup port, Up or Down, and reports the current port in use.
show bridge interfaces
Displays bridge interfaces maintained by the Motorola Netopia® Gateway.
show bridge table
Displays the bridging table maintained by the Motorola Netopia® Gateway.
show config
Dumps the Motorola Netopia® Gateway’s configuration script just as the script command does in config mode.
232
