Motorola 3342, 7000 Set ip ethernet a subnet n address ipaddress, Set ip gateway option on off

set ip ethernet A subnet n address ip_address

Specifies an IP address for the subnet n, when subnet n option is on.

set ip ethernet A subnet n netmask netmask

Specifies the subnet mask for the subnet n, when subnet n option is on.

Default IP Gateway Settings

set ip gateway option { on off }

Specifies whether the Motorola Netopia® Gateway should send packets to a default Gateway if it does not know how to reach the destination host.

set ip gateway interface { ip-address ppp-vccn }

Specifies how the Motorola Netopia® Gateway should route information to the default Gateway. If you select ip-address, you must enter the IP address of a host on a local or remote network. If you specify ppp, the Motorola Netopia® unit uses the default gateway being used by the remote PPP peer.

IP-over-PPP Settings. Use the following commands to configure settings for routing IP over a virtual PPP interface.

☛NOTE:

For a DSL platform you must identify the virtual PPP interface [vccn], a number from 1 to 8.

set ip ip-ppp [vccn] option { on off }

Enables or disables IP routing through the virtual PPP interface. By default, IP routing is turned on. If you turn off IP routing and save the new configuration, the Motorola Netopia® Gateway clears IP routing set- tings

set ip ip-ppp [vccn] address ip_address

Assigns an IP address to the virtual PPP interface. If you specify an IP address other than 0.0.0.0, your Motorola Netopia® Gateway will not negotiate its IP address with the remote peer. If the remote peer does not accept the IP address specified in the ip_address argument as valid, the link will not come up.

The default value for the ip_address argument is 0.0.0.0, which indicates that the virtual PPP interface will use the IP address assigned to it by the remote peer. Note that the remote peer must be configured to supply an IP address to your Motorola Netopia® Gateway if you enter 0.0.0.0 for the ip_address argu- ment.

263