Panasonic KX-TVS80, KX-TVS50 installation manual Notification Setting Device, 199

B2 SYSTEM ADMINISTRATION - MAILBOXES

Notification Setting - Device 1-3

		Table 36
Parameter	Value Range	Description/Function
	(Default)
Dial Number	Up to 32 digits	Assigns a telephone or beeper number to Device 1, 2, or
	consisting of 1-9,	3. The subscriber can also specify the dial number from
	0, , #	his telephone.
	P, T, M, X	P: Pause
	(None)	T: Dial Tone Detection
		M: Dial Mode Switching Code (DTMF to Pulse, or
		Pulse to DTMF)
		X: Callback Number Entry Code
		1-9, 0, , #: Dial Codes
		Note: The callback number entry code "X" must be
		included in the number to be called if the Beeper
		Callback No. Entry Mode is enabled through COS and
		"Type of Device" is set to "Beeper." The proper number
		of "Pauses" must be inserted before the callback entry
		code.
		The Subscriber can also specify the dial number.
Type of Device	1. Telephone	Specifies the device to be notified. This is automatically
	2. Beeper	set to "Beeper" when "X" is used in the Dial Number
	(Telephone)	(above). The Subscriber can also specify the type of
		device from his telephone.
Use Mode	1. Not Use	Specifies how Device 1, 2, or 3 is to be used. The
	2. Continuously	Subscriber can also specify the use mode from his
	3. Scheduled	telephone.
	(Continuously)
		1.Not Use - Device 1, 2, or 3 is not used for a
		notification call.
		2.Continuously - Device 1, 2, or 3 is called whenever a
		message is recorded in the mailbox.
		3.Scheduled - Device 1, 2, or 3 is called on a schedule
		basis when a message has been left in the mailbox.
No. of Retries	0-9 times	Specifies the number of times that a notification call to
	(0)	Device 1, 2, or 3 should be attempted after a busy or no
		answer condition is received
Busy Delay	0-120 min	Specifies the time (in minutes) the VPS must wait after
Time	(3)	a busy condition is received before making a
		notification call to Device 1, 2, or 3.

SYSTEM ADMINISTRATOR'S GUIDE 199