Panasonic KX-TVS80, KX-TVS50 installation manual 251

B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS

To program the following 10 Parameters on the following page, use the Special Commands and Dial Codes listed below. Up to 12 digits can be set for each parameter.

D:Disconnecting

F:Hook Flash

R:Ringback Tone Detection

S:Silence Detection

T:Dial Tone Detection

W:Wait for 1 s

X:Extension dialing

A:Answer

1-9, 0, , #: Dial Codes

		Table 68
Parameter	Value Range	Description/Function
	(Default)
Operator		This sequence is performed by the VPS when transferring
Transfer	(FX)	calls to the operator's extension.
Sequence
Extension		This sequence is performed by the VPS when transferring
Transfer	(FX)	calls to any extension except the operator's.
Sequence
Alternate		This sequence is performed by the VPS when transferring
Extension	(FX)	calls to extensions in the Alternate Extension Group.
Transfer
Sequence
Reconnect		If an extension is busy, this sequence allows the VPS to
Sequence on	(F)	reconnect to the caller.
Busy
Reconnect		If the extension does not answer, this sequence allows the
Sequence on	(F)	VPS to reconnect with the caller.
No Answer
Reconnect		This sequence is performed by the VPS to retrieve a call
Sequence on	(F)	placed on hold after the extension (in the Call Screening
Refuse Call		mode) has refused to accept it.
Light-On		The dialing sequence that the VPS must perform to enable
Sequence for	(None)	the Message Waiting Lamp at an extension.
Message
Waiting Lamp
Light-Off		This is the dialing sequence that the VPS must perform to
Sequence for	(None)	disable the Message Waiting Lamp at an extension.
Message
Waiting Lamp

SYSTEM ADMINISTRATOR'S GUIDE 251