Panasonic KX-TVS50, KX-TVS80 installation manual Cause Action, On Line MODE** is displayed

4.2CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TA624

Screen output:

Active COs: 1 2

APT Interface Connection is not Established ** OFF LINE MODE **

This message is shown when the digital (APT) connection between the VPS and telephone system cannot be established.

Possible causes of the message: "APT Interface Connection is not Established"

Table 15

Cause	Action
The PBX is not a KX-TA624 system.	Change the PBX type by using
Since the default PBX type for the	Quick Setup (see Section 5).
KX-TVS50/80 is to KX-TA624 at the
factory, this message will always
appear when connecting to another
type of PBX.
The cabling between the PBX	Confirm the cabling is
extension ports and the VPS is not 4-	connected as described in
wire or is improperly connected.	Section 2 INSTALLATION.
The PBX is a KX-TA624 but does not	Contact National Parts Center
have the proper level of software	at 1-800-833-9626
required to support APT Integration.	or use Inband Integration under
	hardware settings.
The PBX is not programmed properly	Do required integration
to support APT Integration.	programming as described in
	this chapter.

11.Start up completed.

a)The Power Indicator light stops blinking when the start-up has been successful. (The delay varies according to the system's condition.)

b)"**ON LINE MODE**" is displayed.

c)System prompt [>] is displayed on the screen. To enter system administration, Press ENTER. All parameters can be set through the menu-driven program.

12.Go to the System Administration Top Menu. Type [5] and Press ENTER, or Type [3] then QSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.

70 INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX