Panasonic KX-TVS50, KX-TVS80 installation manual = the port number you entered in program

4.3CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD308

From the SYS-PGM NO ? screen:

a)Enter [118].

b)Press the NEXT button (SP-PHONE). Screen output: VM NO?

c)Press the NEXT button (SP-PHONE). Screen output: VM-01:#_ _ -1: 165

( _ _ = the port number you entered in program 117)

d)Enter the extension number that you want this port to have. (The default extension number for port 1: 165; port 2: 166)

e)Press STORE.

f)Repeat c, d, and e until all extension numbers are entered.

Conditions:	No 2 jacks on the system can have the same extension
	number. If you try to enter a number that is already
	assigned, you will hear an error tone. Each digital
	extension connected provides 2 Voice Mail ports and
	must have 2 different extension numbers assigned.

6.Unplug or power down the KX-TD1232.

7.Connect the jack assigned in Step 3 to the KX-TVS50/80.

8.Connect your laptop computer to the KX-TVS50/80 and start your communication software (i.e., HyperTerminal, Procomm Plus, Smartcom...).

Communication Parameters: 9600, 8 Bit, None, 1

9.Disconnect the power from the VPS and set the DIP switch to position 5.

Only perform this step when initially setting up the system.

CAUTION

Set the DIP switch to position 5 will default the Voice Processing System, resulting in a loss of all user programming and voice messages.

10.Plug in and power up the KX-TVS50/80 and wait approximately 90 s while the system initializes.

"System Administration" Start-Up Sequence

Before starting the VPS, make sure all installation and line connections have been done as described in Section 2.

Plug in and turn the power switch to ON on the KX-TD1232. The calls to the VPS can be

74 INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX