Panasonic KX-TVS50, KX-TVS80 installation manual Other Parameters External Message Delivery, 238

B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS

		Table 56
Parameter	Value Range	Description/Function
	(Default)
Message	Port No.	Specifies the port numbers used for the Message Waiting
Waiting Lamp	(1, 2)	Notification Lamp feature.
Ports
		The VPS turns on the Message Waiting Lamp of the
		extension using the port specified in this field. At least 1
		port must be specified.
Message	1. No	When set to "Yes," the VPS will turn on the Message
Waiting Lamp	2. Yes	Waiting Lamp of the extension each time a new message
for Every	(Yes)	is recorded in the mailbox. This will occur even if the
Message		Message Waiting Lamp was not turned off from a
		previous message. This setting is useful when the first
		attempt is unsuccessful.
		When set to "No," the VPS will turn on the Message
		Waiting Lamp for the first message only. The VPS will
		not turn on the lamp for subsequent messages until the
		Subscriber has accessed the VPS to retrieve the messages
		stored there.
Max. Digits for	1-48 digits	Specifies the maximum number of digits the caller can
Callback No.	(20)	enter as a callback number. This number will be
		displayed on beepers if the "Beeper Callback No. Entry
		Mode" is enabled.
Callback No.	1-10 s	Sets the maximum allowable time between each digit on
Entry Interdigit	(5)	Beeper Callback No. Entry. If the caller does not enter
Time-Out		any digits within the specified time, the VPS will not
		accept entry of any additional digits.
System	Up to 32 digits	Specifies a telephone number displayed on the
Callback No.	(None)	Subscriber's beeper as a callback number when "Type" is
		set to "Beeper."
		Note: If "Beeper Callback No. Entry Mode" is enabled
		through COS, the callback number entered by the caller
		will be displayed on the destination beeper instead of the
		System Callback No. However, if the caller fails to enter
		a callback number, the System Callback No. will be
		displayed.

Other Parameters - External Message Delivery

Used to control the handling of External Message Delivery calls.

238 SYSTEM ADMINISTRATOR'S GUIDE