Panasonic KX-TVS80 installation manual Set the DIP switch on the KX-TVS50/80 to position

4.3CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD308

5.Unplug or power down the KX-TD308.

6.Connect the jack assigned in Step 3 to the KX-TVS50/80.

7.Connect your laptop computer to the KX-TVS50/80 and start your communication software (i.e., HyperTerminal, Procomm Plus, Smartcom...).

Communication Parameters: 9600, 8 Bit, None, 1

8.Set the DIP switch on the KX-TVS50/80 to position 5.

Only perform this step when initially setting up the system.

CAUTION

Set the DIP switch to position 5 will default the Voice Processing System, resulting in a loss of all user programming and voice messages.

9.Plug in and power up the KX-TVS50/80 and wait approximately 90 s while the system initializes.

"System Administration" Start-Up Sequence

Before starting the VPS, make sure all installation and line connections have been done as described in Section 2.

Plug in and turn the power switch to ON on the KX-TD308. The calls to the VPS can be processed after the Power Indicator stops flashing.

After turning the power on, the system starts up in the following sequence:

•The Power Indicator light goes on.

•The Power Indicator light begins to flash.

•"Checking Flash Memory Cards." is displayed on the screen.

Screen output:

Checking Flash Memory Cards.

Please wait...

PORT TEST...

SYSTEM SETUP

1... 2... 3...

•The VPS tests the CPU card, the flash memory, and the ports until "1...2...3..." is displayed.

•Active ports are displayed on the screen.

82 INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX