Panasonic KX-TVS50, KX-TVS80 installation manual Cause Action

4.3CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD308

Table 16

Cause	Action
The PBX is a KX-TD series but does	Contact National Parts Center
not have the proper level of software	at 1-800-833-9626
required to support DPT Integration.	or use Inband Integration under
	hardware settings.
The PBX is not programmed properly	Do required integration
to support DPT Integration.	programming as described in
	this chapter.

11.Start up completed.

a)The Power Indicator light stops blinking when the start-up has been successful. (The delay varies according to the system's condition.)

b)"**ON LINE MODE**" is displayed.

c)System prompt [>] is displayed on the screen. To enter system administration, Press ENTER. All parameters can be set through the menu-driven program.

12.Go to the System Administration Top Menu. Type [5] and Press ENTER, or Type [3] then QSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.

TEST: Press the INTERCOM button and then [165]. If the VPS answers, you have a DPT connection.

Set the DIP switch to position 0 after initialization is complete.

The required programming is complete and the VPS and KX-TD1232 should be able to communicate through Digital Integration.

When running the Quick Setup command (Section 5 CUSTOMIZING THE SYSTEM) from the VPS, the PBX transmits the station information automatically. This saves time when programming the VPS.

4.3.2KX-TD1232 Software Verification and Programming for Digital Integration via the Operating and Maintenance Tool

Follow these steps after communication between the KX-TD1232 and the programming software has been established. Refer to the Operating and Maintenance manual for connection information.

1.Check the software version.

a) Go to the Main Menu. Press the ALT key and the letter [V] at the same time.

76 INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX