Panasonic KX-TVS50, KX-TVS80 installation manual 250, Inband The PBX sends Dtmf tone codes to

B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS

*1	When your KX-TD series telephone system is in DPT Integration mode.
*2	When your KX-TA624 telephone system is in APT Integration mode.
N/A Not available

—Not needed

		Table 67
Parameter	Value Range	Description/Function
	(Default)
Integration	1. None	Specifies the method of integrating the VPS with the
Mode	2. Inband	PBX.
	3. APT	1. None - Both PBX and VPS work independently,
	4. DPT
		without accessing information concerning the status
	(TVS50: APT
		of the other.
	TVS80: DPT)
		2. Inband - The PBX sends DTMF tone codes to the
		VPS to indicate the state of the call (busy, answered,
		disconnect, etc.). VPS performance is improved with
		Inband Integration because call state recognition is
		faster than with standard call progress tone detection.
		The PBX code for each call state must be set in the
		Inband Signaling Parameters. If PBX type is set to a
		KX-T series telephone system, the Inband Signaling
		Parameters will automatically default to the proper
		codes. This is available with any of the following
		Panasonic KX-T series telephone systems: T1232,
		TA series, T96, T336, TD816, TD1232, TD308.
		3. APT - The VPS communicates with the PBX via the
		APT interface. This is available only with Panasonic
		KX-TA624.
		4. DPT - The VPS communicates with the PBX via the
		DPT interface. This is available with any of the
		following Panasonic KX-TD series telephone
		systems:TD816, TD1232, TD308.
		If set to "APT" or "DPT", the extension numbers of VPS
		Port 1 and VPS Port 2 can be assigned in sub-parameter.
Extension	2-5 digits	Specifies the extension number of VPS port 1.
Number of	(TA624: 107
VPS Port 1	TD816/1232: 165
	TD308: 295)
Extension	2-5 digits	Specifies the extension number of VPS port 2.
Number of	(TA624: 108
VPS Port 2	TD816/1232: 166
	TD308: 296)

250 SYSTEM ADMINISTRATOR'S GUIDE