Panasonic KX-TVS80, KX-TVS50 installation manual On Line MODE** is displayed

4.3CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD308

Screen output:

Active COs: 1 2

APT Interface Connection is not Established ** OFF LINE MODE **

This message is shown when the digital (DPT) connection between the VPS and telephone system cannot be established. This is normal. This message appears because the PBX type for the VPS is not a KX-TD series system. Since the default PBX type is set to the KX-TA series at the factory, this message will always appear. To change the default, go to the System Administration Top Menu, and Type 1-6-3-1. (Program - Hardware Settings - PBX Interface Parameters - Dialing Parameters Menu). Select "2:KXT Series" at the "1. PBX Type", and select "4:DPT" at the "2. Integration Mode".

Exit the menu by entering "\", and the following display will be shown.

Screen output:

** OFF LINE MODE **

If "DPT Interface Connection is not Established" is still shown, possible causes are:

Table 17

Cause	Action
The cabling between the PBX	Confirm the cabling is
extension ports and the VPS is not 4-	connected as described in
wire or is improperly connected.	Section 2 INSTALLATION.
The PBX is a KX-TD series but does	Contact National Parts Center
not have the proper level of software	at 1-800-833-9626
required to support DPT Integration.	or use Inband Integration under
	hardware settings.
The PBX is not programmed properly	Do required integration
to support DPT Integration.	programming as described in
	this chapter.

10.Start up completed.

a)The Power Indicator light stops blinking when the start-up has been successful. (The delay varies according to the system's condition.)

b)"**ON LINE MODE**" is displayed.

c)System prompt [>] is displayed on the screen. To enter system administration, Press ENTER. All parameters can be set through the menu-driven program.

11.Go to the System Administration Top Menu. Type [5] and Press ENTER, or Type [3] then QSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.

INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX 83