Pelco DX4600 manual PTZ Control

PTZ Control

The PTZ control is available for cameras that support PTZ functions using Pelco C, Pelco P, and D protocols. It is also available for supported third- party dome cameras. In addition, the PTZ option must be enabled and a protocol must be assigned to the camera channel. For information about configuring camera features, refer to Camera Menu Setup on page 27. For information using the KBD300A keyboard to operate PTZ devices, refer to Activating Presets on page 100.

NOTE: When operating third-party cameras, the PTZ control supports the up, down, left, right, zoom in, and zoom out functions.

Figure 4. PTZ Control

	Move: Pan and tilts the camera in the direction of the selected arrow.
	Exit: Closes the PTZ control.
	ZOOM: Zooms the camera in and out.
ZOOM
	FOCUS: Adjusts the camera focus.
FOCUS
	IRIS: Opens and closes the camera iris.
IRIS
	PRESET NUMBER: Displays the preset number.
	Keypad: Enters presets or pattern numbers.
PRESET	PRESET: Performs two functions:
	• Preset programming mode: Stores the preset in the selected memory location.
	• PTZ mode: Activates a preset.

PATTERN PATTERN: Performs two functions:

•Pattern programming mode: Stores the pattern in the selected memory location.

•PTZ mode: Activates a pattern.

CLR	Clear: Deletes a programmed preset, pattern, or tour.
PGM	Program: Accesses the camera programming mode.
AUX	Auxiliary: Selects the auxiliary mode. Buttons 1–4 select the camera’s auxiliary outputs. Buttons 1–4
	operate as a toggle (on/off) each time they are selected.
SET	SET: Performs two functions:
	•	Enters PTZ programming mode.
	•	Exits PTZ programming mode.

C2674M-C (7/09) 15