Siemens S5-135U/155U appendix Removing Inserting Module Insertion

CPUs, Memory Cards, Memory Submodules, Interface Submodules

Removing and

Inserting the

Module

!

Insertion

Note

All other jumpers are required for quality testing by the manufacturer. You must not change these jumper settings.

Caution

Switch off the power supply before removing or inserting the module.

The basic board and expansion board of the CPU 948 are one unit and must not be separated.

Proceed as follows to insert the CPU in the central controller:

Step Action

1Release the upper locking bar of the central controller and ensure that the locking pin for the module is correctly positioned with the slot-head horizontal.

2Select the correct slot (based on the labelling of the locking bar). Insert the CPUs in the S5-135U/155U PLC from the extreme left at slot 11.

3Push the module evenly into the guide rail until the lever over the locking pin is horizontal.

4Press the locking pin inwards on the bottom of the module and rotate it 90_ clockwise.

5Secure the upper locking bar.

Removal Proceed as follows to remove the CPU:

Step

Action

1

2

3

Release the upper locking bar of the central controller.

Release the locking pin of the module.

Press the release lever downwards and pull the module forwards and out of the central controller.

System Manual	5-19
C79000-G8576-C199-06