Siemens S5-135U/155U appendix Second Interface SI2

CPUs, Memory Cards, Memory Submodules, Interface Submodules

Second Interface SI2

You can optionally use the second interface of the CPU 928B as:

SA PG interface (for PG and operator panels)

SInterface for the RK 512 computer link

SInterface for data transmission with procedures 3964/3964R

SInterface for data transmission with the ªopen driverº

SInterface for data transmission via the SINEC L1 bus (from Version 6ES5 928-3UB12).

To utilize the second interface as the PG interface, you need the

SRG submodule

You need one of the following interface submodules for the RK 512 computer link, for data transmission with procedures 3964/3964R and for data transmission with the ªopen driverº:

SV.24 submodule (RS 232C)

STTY submodule

SRS422 A/485 submodule (only in the RS422 A mode).

To utilize the second interface for data transmission via the SINEC L1 bus, you need the

SSINEC L1 submodule (from Version 6ES5 928-3UB12).

The CPU 928B is delivered without an interface submodule. You can operate the CPU 928B without an integral interface submodule. The opening to accept a submodule in the front plate is closed by a cover. Only remove the cover to fit an interface submodule.

A description of interface submodules can be found in Section 5.11, and the order numbers in the ordering information.

A detailed description of the second interface can be found in the

CPU 928B/CPU 948 Communication Manual.

Process Interrupt There is an interrupt line in the PLC for each CPU. It can be used when the

Processingreaction to an event must occur with higher priority than the reaction to other events.

To process an interrupt, cyclic program processing is interrupted and the program stored in OB 2 (OB for interrupt processing) is inserted (refer to the CPU 928B -3UB21 Programming Guide for further details).

This interrupt-driven program processing is only possible using an interrupt-capable digital input module or a suitable operating CP/IP module.

No jumper setting on the CPU 928B is required. Please note, however, that the usable interrupt line on the backplane bus depends on the CPU slot and must be set accordingly on the I/O module (see Section 4.1).

5-32	System Manual
	C79000-G8576-C199-06