Talkswitch 24-CA, 48-CA/CVA manual Verifying the Connections, File Update Firmware

Line 1, 2, 3 and 4 lights flashing simultaneously:

The firmware needs to be updated or reloaded. Ensure that you update with the last version, do not use the version on the installation CD. There might be a newer version. Open the TalkSwitch configuration software.

File -> Update Firmware...

Line 1 and 4, then Line 2 and 3, lights flashing alternatively:

The system prompts are not loaded or corrupted. Reload the firmware. Open the TalkSwitch configuration software.

File -> Update Firmware...

Line 1 and 3 lights, then Line 2 and 4 lights flashing repeatedly: This is usually the case after a firmware update. Reboot TalkSwitch.

Tools -> Reboot TalkSwitch or, on the front panel, turn the power button off and back on.

1.13 VERIFYING THE CONNECTIONS

If you are having problems, they could be due to loose cables. Check the following:

1.Are your telephone cables connected to a wall jack at one end and the unit at the other? Ensure the devices you are using as extensions (phones, faxes, etc.) are plugged into the extension jacks located on the back panel of the unit. Do not plug your extensions directly into a wall jack unless that jack is wired to a unit extension jack.

2.Check the Serial, USB or LAN connection between TalkSwitch and your PC.

3.Ensure that the unit AC adapter is plugged into a working power outlet and that the unit is turned on. Make sure that you are using the

AC adapter supplied with your unit. This adapter cannot be substituted with any other adapter. If your adapter appears to be defective, please contact your TalkSwitch dealer to order the proper replacement.

4.If networked, ensure that you have the latest firmware loaded on all units. To check the firmware version, open the configuration software, and click the link View System Information. All units listed in the System Information dialog box should have the same firmware version.

2 8 T A L K S W I T C H U S E R G U I D E • N O R T H A M E R I C A