Tektronix 071-0590-00 user manual Connectors, Terminations, and Levels

Functional Overview

Connectors, Terminations, and Levels

Tables 2-1 and 2-2 below summarize the physical interface characteristics of all

GB1400 Generator and Analyzer inputs and outputs.

Table 2-1. Generator (Tx) Inputs and Outputs

Connector Label	Signal Type	Location	Connector	Impedance, amplitude,
			Type	and offset
DATA	output	OUTPUT section	SMA,	50	Ohm, see NOTE 1,
			female	variable amplitude and
				offset
CLOCK	output	OUTPUT section	SMA,	50	Ohm, see NOTE 1,
			female	variable amplitude and
				offset
DATA-BAR	output	OUTPUT section	SMA,	50	Ohm, see NOTE 1,
			female	variable amplitude and
				offset
CLOCK-BAR	output	OUTPUT section	SMA,	50	Ohm, see NOTE 1,
			female	variable amplitude and
				offset
CLOCK/4	output	OUTPUT section	SMA,	50 Ohm, 200mV into 50Ω
			female
PATTERN SYNC	output	OUTPUT section	SMA,	50 Ohm, 200mV into 50Ω
			female
CLOCK INPUT	input	CLOCK section	SMA,	50	Ohm, 2V max, see
			female	NOTE 2
DATA INHIBIT	input	rear panel	BNC,	50	Ohm to -2V, ECL
			female
ERROR INJECT	input	rear panel	BNC,	50	Ohm to -2V, ECL
			female
RS-232	I/O	rear panel	25 pin, D	RS-232C standard levels
			type	and impedance
GPIB	I/O	rear panel	GPIB	IEEE-488 standard levels
				and impedance

Note 1: A 75-Ohm version of the GB1400 is an option.

Note2: BURST Mode units require ECL-level inputs and are terminated with 50-Ohms to -2V.

2-16 GB1400 User Manual