Tektronix 071-0590-00 user manual End-of-Test Reports, Example End-of-Test Report

Reference

End-of-Test Reports

When End-of-Test reports are enabled, one End-of-Test report will be generated each time the end of a Test interval is reached. This can occur automatically, when timing mode is set to Timed or Repeat, or manually when the user stops an Untimed test by pressing the CLEAR key. Use the REPORT parameter in the TEST Menu to enable or disable End-of-Test reports. An example End-of-Test report is shown below.

Example End-of-Test Report

--------------------------------------------------------------------------------------------------

Tektronix, Inc. GB-1400 TEST SUMMARY				Jun/14/99 02:42:48
TEST MODE:	TIMED			FREQ:	100.0 MHz	ERROR THRES: E-05
TIME				ALARMS		PERFORMANCE
START Jun/14/99 02:43:26			SIG LOSS		OS US 0 0.0%
STOP Jun/14/99 0s:43:31			SYNC LOSS	OS SES 0 0.0%
ELAPSED 000-00:00:05		PHASE ERR OS TES 5 100.0%
	ES 5 100.0%
ERRORS/BITS		EFS 0 0.0%
TOTAL ERRS	000050000		AVG RATE		1.0E-04 DM 0 0.0%
TOTAL BITS	500002816		CUR RATE		1.0E-04

--------------------------------------------------------------------------------------------------

You can set up the Analyzer to generate End-of-Test Reports as follows:

Procedure to Enable or Disable End-of-Test Reports

1.Complete the basic report setup procedure.

2.Press F1 to enter the Menu system.

3.Select the TEST Menu (F2).

4.Select the REPORT parameter (F4).

5.You may now either enable End-of-Test reports by selecting END OF TEST or EOT/ERROR; or disable End-of-Test reports, by selecting NONE.

6.Press F4 to lock in you selection.

7.Press F1 multiple times until you have exited the Menu system.

GB1400 User Manual 3-39