AT&T 518-455-317 manual Programming

Feature Reference 5

Overview

This chapter provides reference information for programming and using system features. Features are listed in alphabetical order. System Programming procedures include the procedure code (# and three-digit number) in the heading; dial-code features include the feature code (F for [ Feature ] or I for

[ Intercom ], plus a two-digit code). Some feature codes also include a variable:

XXfor a two-digit extension number from 10–57, LL for a two-digit line number from 01–24, or G for a single-digit group number. Headings without codes are general call-handling topics or Telephone Programming procedures.

Each feature includes the following information, if applicable:

■	Description	Examples
■	Related Features	Programming
■	Considerations	Using

■Valid Entries ( ✔ = factory setting)

This chapter gives step-by-step instructions, using the following conventions:

■Programming instructions tell you to use the [ Next Data ] button to change values for specific settings. You can, however, enter a value using the keypad if you prefer. Similarly, there are different ways to exit programming mode as described in Chapter 2—use the method with which you are most comfortable.

■For Telephone Programming, this chapter provides only the instructions for Centralized Telephone Programming. To program from individual extensions, users should refer to their Quick Reference cards.

All of the instructions in this chapter assume that system phones select outside lines first and standard phones select intercom first (as determined by each extension’s setting for Automatic Line Selection).

See Chapter 2 for a review of the methods and buttons you can use while in programming mode.

Overview 5-1