Doorphone Alert Extensions (#606)

Description

This System Programming procedure identifies up to 48 extensions to signal when a doorphone button is pressed. When a person uses the doorphone, it signals all alert extensions at the same time. If the alert extension is a system phone, the call signals with a unique ding-dongsound to distinguish it from other calls. Additionally, if you have two doorphones, they signal with different tones so you can distinguish between them.

Related Features

You must use Doorphone Extensions (#604 and #605) to identify the extensions to which doorphones are connected.

If Do Not Disturb is active at a doorphone alert extension, the person at the doorphone hears signaling, but the alert extension is not signaled.

Considerations

You cannot bridge two doorphones together.

Valid Entries

1

= Not an Alert Extension

2

= Doorphone 1 Alert Extension

3

= Doorphone 2 Alert Extension

4

= Doorphones 1 and 2 Alert Extension

Programming

To identify doorphone alert extensions:

1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 6 ] [ 0 ] [ 6 ]. The

display reads:

DoorPhneAlert

Extension:

2.Enter the first alert extension number (10–57). For example, to identify extension 10, press [ 1 ] [ 0 ].

3.To change the alert status, press [ Next Data ] until the appropriate value displays.

4.To identify another alert extension, press [ Next Item ] or [ Prev Item ] until the extension number shows on the display. Then repeat Step 3.

5.Select another procedure or exit programming mode.

Doorphone Alert Extensions (#606) 5-59

Page 142
Image 142
AT&T 518-455-317 manual Doorphone Alert Extensions #606, DoorPhneAlert Extension