
Chapter 5 | CLI – Layer 2 |
|
|
• | set port spantree | Enables or disables the spanning tree for | Page 102 |
|
| switch ports |
|
• | set port spantree | Set the port spantree priority level | Page 103 |
| priority |
|
|
• | set port spantree cost | Set the port spantree cost | Page 103 |
• | set port security | Enables MAC security on a range of | Page 104 |
|
| ports |
|
• | set cascading | Sets module cascading | Page 104 |
|
| mode |
|
• | set inband vlan | Set the management VLAN ID | Page 104 |
• | set vlan | Creates VLANs | Page 105 |
• | set port flowcontrol | Set the flow control mode of a port | Page 105 |
• | set port | Page 106 | |
• Set the flowcontrol advertising capabilities of a Gigabit port |
| ||
• | set trunk | Set the tagging mode of a port | Page 106 |
• | set spantree | Enable/Disable Spanning Tree Protocol | Page 107 |
|
| (STP) |
|
•set spantree priority
•set autopartition
•set license
•set ppp authentication
•set ppp incoming timeout
•set ppp
•set web
•set
•set
Set the STP Bridge priority level | Page 107 |
To enable or disable autopartitioning for | Page 107 |
modules in a stack |
|
Enter a license number for the stack | Page 109 |
Defines the PPP authentication method | Page 109 |
Sets the time after which the system | Page 110 |
automatically disconnects an idle PPP |
|
incoming session |
|
Sets the baud rate used in PPP sessions | Page 110 |
Set the location (url/directory) of the | Page 110 |
P330 Device Manager Help files |
|
Enables or disables the IP multicast | Page 111 |
filtering application |
|
Sets the aging time for client ports | Page 111 |
84 |