|
|
|
| Chapter 5 CLI – Layer 2 |
|
|
|
|
|
# | Module |
| Cascade | |
| ||||
1 | Support | IPMc | Not Installed | Support IPMc |
Show security mode Command
Use the show security mode command to display the status of the MAC security feature.
The syntax for this command is:
show security mode
Example:
Security mode enabled.
Note: Layer 2 commands are only available if you open a switch session with the Master module.
Note: The Show security mode command does not apply to the
Show arp-tx-interval Command
Use the show
The syntax for this command is:
show arp-tx-interval
Example:
ARP tx interval is set to 5 seconds.
Show
Use this command to display the arp aging interval.
The syntax for this command is:
show arp-aging-interval
73 |
