
Chapter 5 | CLI – Layer 2 |
|
|
Note: Create the file into which you wish to upload the
The syntax for this command is:
copy stack-config tftp <filename> <ip>
filename | file name (full path) |
ip | The ip address of the TFTP server |
Example:
P330-N# copy stack-config tftp c:\conf.cfg 192.168.49.10
Beginning upload operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
For more information , use 'upload status' command
********************************************************************
*If you are currently running the P330 Device Manager application,*
*it is recommended to exit from it before performing configuration*
* download operations.*
********************************************************************
Copy module-config tftp Command
Use the copy
If an error occurred during upload (you can check this using the command show tftp upload status) you must fix the problem. The following is a list of possible problems:
aYou did not create an empty text file at the destination server (0 Bytes).
bYou do not have the correct path to the file.
cThe destination server is not active/on.
dThe destination server is unreachable.
Then, perform the upload procedure again twice as follows:
aDelete the destination file and recreate a correctly named empty file at the destination server (0 Bytes)
bType the command copy
cDelete the destination file and recreate a correctly named empty file at the destination server (0 Bytes)
dType the command copy
118 |