Avaya P332G-ML manual Set port enable Command, Set port disable Command, Set port speed Command

Chapter 5 CLI – Layer 2

Set port enable Command

Use the set port enable command to enable a port or a range of ports.

The syntax for this command is:

set port enable [mod_num/port_num]

mod _num	The module number
port_num	The port number

Example:

To enable port 3 on module 2:

P330-N# set port enable 2/3

Port 2/3 enabled.

Set port disable Command

Use the set port disable command to disable a port.

The syntax for this command is:

set port disable <mod_num>/<port_num>

Example:

P330-N# set port disable 5/10

Port 5/10 disabled.

Set port speed Command

Use the set port speed command to configure the speed of a 10/100Base-T port. If autonegotiation mode is enabled for such ports, the port's speed is determined by autonegotiation, and an error message is thus generated if you attempt to perform the set port speed command in this case.

The syntax for this command is:

set port speed <mod_num>/<port_num> {value}

Example:

To configure port 2 on module 2 port speed to 10 Mbps:

P330-N# set port speed 2/2 10MB

Port 2/2 speed set to 10 Mbps.

94 P332G-ML User’s Guide