Chapter 5

CLI – Layer 2

 

 

Set device-mode Command

Use the device-modecommand to change the Basic Mode of Operation of the P332-ML Module between Router and Layer 2 modes.

The syntax for this command is:

set device-mode <mode>

mode

Router Layer2

Set interface Command

Use the set interface command to configure the management interface on the Master agent of the stack.

The syntax for this command is:

set interface inband <vlan> <ip_addr> <netmask>

inband

Interface name used for the management

vlan

The number of the VLAN to be used for management

ip_addr

IP address used for managing the stack

netmask

Subnet mask of the management interface

Example:

P330-N# set interface inband 1 192.168.42.252 255.255.255.0

Interface inband IP address set.

You must reset the device in order for the change to take effect.

Set interface ppp Command

Use the set interface ppp command to configure the P330 PPP interface IP parameters, exit modem mode, disconnect the PPP session, or reset the connected modem.

A PPP connection can be established only after the P330 is configured with an IP address and net-mask. The IP address is a dummy address that is shared between two peers, and must be taken from a subnet that is different from the agent’s IP sub- net.

P332G-ML User’s Guide

91

Page 109
Image 109
Avaya P332G-ML manual Set device-mode Command, Set device-mode mode, Set interface Command, Set interface ppp Command