Avaya P332G-ML manual Installation and Setup, Installing the X330STK-ML Stacking Sub-Module

Chapter 4

Installation and Setup

The P332G-ML is ready to work after you complete the installation instructions below. The P332G-ML ports provide complete connectivity and no configuration is required to make the system work.

Installing the X330STK-ML Stacking Sub-Module

Caution: The stacking sub-modules contain components sensitive to electrostatic discharge. Do not touch the circuit board unless instructed to do so.

To install the stacking sub-module in the P332G-ML:

1Remove the blanking plate from the back of the P332G-ML switch.

2Insert the stacking sub-module gently into the slot, ensuring that the metal base plate is aligned with the guide rails. The metal plate of the X330STK-ML (and not the PCB) fits onto the guide rails.

3Press the sub-module in firmly until it is completely inserted into the P332G-ML.

4Gently turn the two screws on the side panel of the stacking sub-module until they are secure.

Note: The P332G-ML must not be operated with the back-slot open. The stacking sub- module should be covered with the supplied blanking plate if necessary.

Note: Only use the X330STK-ML stacking module with the P332G-ML.

P332G-ML User’s Guide 25