Avaya P332G-ML Set port auto-negotiation-flowcontrol-advertisement Command, Set trunk Command

Chapter 5 CLI – Layer 2

Set port auto-negotiation-flowcontrol-advertisement Command

The set port auto-negotiation-flowcontrol-advertisementcommand sets the flowcontrol advertisement for a Gigabit port when performing autonegotiation.

The syntax for this command is:

set port auto-negotiation-flowcontrol-advertisement <mod_num>/

<port_num> {no-flowcontrolasym-tx-onlysym-onlysym-and-asym-rx}

no-flowcontrol asym-tx-only sym-only sym-and-asym-rx

Example:

The port will advertise no pause capabilities

The port will advertise asymmetric Tx pause capabilities only The port will advertise symmetric pause capabilities only

The port will advertise both symmetric and asymmetric Rx pause capabilities

P330-N# set port auto-negotiation-flowcontrol-advertisement 1/5 asym-tx-only

P330-N# Port 1/5 pause capabilities was set

Set trunk Command

Use the set trunk command to configure the tagging mode of a post.

set trunk [module/port] [value]

module/port module/port number

valueoff/dot1q

Example:

P330-1(super)# set trunk 2/20 dot1q

Dot1Q VLAN tagging set on port 2/20.

Set spantree Commands

Use the set spantree command to enable/disable the spanning-tree protocol for the stack.

106 P332G-ML User’s Guide