Chapter 5 | CLI – Layer 2 |
|
|
Show rmon history Command
This command shows the most recent RMON history log for a given History Index. The history index is defined using the rmon history command on Page 115 or using an RMON management tool.
The syntax for this command is:
show rmon history [<History Index>]
Example:
Entry 1026 is active, owned by amir
Monitors ifEntry.1.1026 every 30 seconds
Requested # of time intervals, ie buckets, is 20
Granted # of time intervals, ie buckets, is 20
Sample # 1 began measuring at 2:53:9
Received 62545 octets, 642 packets,
391 broadcast and 145 multicast packets,
0 undersize and 0 oversize packets,
0 fragments and 0 jabbers,
0 CRC alignment errors and 0 collisions,
#of dropped packet events (due to a lack of resources): 0 Network utilization is estimated at 0
Show rmon alarm Command
This command shows the parameters set for a specific alarm entry that was set using the rmon alarm command on Page 116 or using the P330 Device Manager.
The syntax for this command is:
show rmon alarm [<Alarm Index>]
Example:
P330-N> show rmon alarm 1026
alarm
alarm 1026 is active, owned by amir Monitors ifEntry.1.1026 every 60 seconds Taking delta samples, last value was 1712
Rising threshold is 10000, assigned to event # 1054
Falling threshold is 10, assigned to event # 1054
On startup enable rising or_falling alarms
68 |
