Avaya P332G-ML manual Set interface ppp enable, CLI responds with the following

Chapter 4 Installation and Setup

5Set the baud rate, ppp authentication, and ppp time out required to match your modem. These commands are described in the “Command Line Interface” chapter.

6At the prompt, type:

set interface ppp enable

The CLI responds with the following:

Entering the Modem mode within 60 seconds...

Please check that the proprietary modem cable is plugged into the console port

7Use the DB-25 to RJ-45 connector to plug the console cable to the modem’s DB- 25 connector. Plug the other end of the cable RJ-45 connector to the

Avaya P332G-ML console’s RJ-45 port.

8The Avaya P332G-ML enters modem mode.

9You can now dial into the switch from a remote station, and open a Telnet session to the PPP interface IP address.

36 P332G-ML User’s Guide